ISO 14253-1, Geometrical product specifications (GPS)一Inspection by measurement of workpieces and measuring equipment一Part 1: Decision rules for proving conformity or nonconformity with specifications ISO 8015, Geometrical product specifications (GPS)一Fundamentals 一Concepts, principles and rules ISO 5459, Geometrical product specifications (GPS)一Geometrical tolerancing一Datums and datum systems
ISO 2639:2002, Steels 一Determination and verification of the depth of carburized and hardened cases ISO 1132-1, Rolling bearings一Tolerances 一Part 1: Terms and definitions Sizes一Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO 286-2, Geometrical product specifications (GPS) 一ISO code system for tolerances on linear ISO 286-1, Geometrical product specifications (GPS)一ISO code system for tolerances on linear sizes一Part 1: Basis of tolerances, deviations and fits ISO 15, Rolling bearings一Radial bearings一Boundary dimensions, general plan ISO/TS 17863, Geometrical product specification (GPS)一Tolerancing of moveable assemblies ISO 14405-1, Geometrical product specifications (GPS)一Dimensional tolerancing一Part 1: Linear sizes ISO 5753-1, Rolling bearings一Internal clearance一Part 1: Radial internal clearance for radial bearings ISO 1101, Geometrical product specifications (GPS)一Geometrical tolerancing一Tolerances of form, orientation, location and run-out ISO 582, Rolling bearings一Chamfer dimensions一Maximum values For undated references, the latest edition of the referenced document (including any amendments) applies. For dated references, only the edition cited applies. The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. Recommended values for the tolerances for shaft raceways for needle roller bearings without inner ring are given in Annex A. These specifications apply to complete needle roller bearings and to bearings without inner ring. This International Standard specifies dimensional and geometrical characteristics, limit deviations from nominal sizes.
BS ISO 1206:2016 pdf free.Rolling bearings一Needle roller bearings with machined ringsīS ISO 1206 specifies the boundary dimensions and normal class tolerance values for needle roller bearings with machined rings.